Is used in mechanically attached and fully adhered roofing systems in new construction, reroofing and recover (retrofit) applications. It may also be used as flexible membrane flashings for walls, curbs, etc, when installing TPO membrane roofing systems. The system must be installed over acceptable roof insulation orother suitable substrate. See the Mule-Hide TPO Specifications Manual for complete specifications and details
Find a Distributor
Features & Benefits
- Available in 4', 6', 8, 10' and 12' widths by 100' length
- 45, 60, 80 mil thickness
- Fully adhered, mechanically attached and ballasted systems
- Available in white, gray and tan
- Both white and tan are energy star
- Most often installed as mechanically attached
- Up to a 30 year system warranty available
- All adhesives must be installed as a 2-sided contact adhesive
- Pre-printed with lap lines and fastener spacing
Insulation - Mechanically Attached
ShapeShift Pitch Pan
TPO - Bare Metal Scuppers
TPO - Coated Scupper
TPO - Curb Flashing 1 Piece
TPO - Curb Flashing 4 Piece
TPO - Drip Edge Bare Metal
TPO - Field Fabricated Corner
TPO - Field Membrane Base Attachment
TPO - Field Sheet Repair
TPO - Fully Adhered
TPO - Hot Air Welding
TPO - Inside Corner
TPO - Mechanically Fastened
TPO - Outside Corners
TPO - Pipe Flashing Field Wrap
TPO - Pipe Flashing Molded Pipe Boot
TPO - Roof Drain
TPO - RUSS Strip 10"
TPO - RUSS Strip 6"
TPO - RUSS Strip wall with Inside Corner
TPO - Sealant Pocket
TPO - Termination bar
TPO - Without RUSS Strip
What are the Warranty Fees for TPO Roofing Systems?
Fees vary depending on the type of warranty desired. Current Fees are listed on Mule-Hide Warranty Application forms.
Do I need Walkway Rolls for a large commercial roofing project?
Walkway Rolls are always recommended. Mule-Hide offers walk pads for each system/membrane type we sell.
Does Mule-Hide require a total tear-off for Labor & Material Warranties?
No, this is not required, but all areas of wet insulation must be replaced with new, dry, similar material, specific warranties may require an independent moisture scan of the roof.
Does Mule-Hide offer any pre-job “walk the roof” or job starts?
Yes, Mule-Hide Territory Managers offer these services.
What if I need to prove Mule-Hide TPO meets a written specification or complies with a UL, FM or other code requirement?
Just provide Mule-Hide with the following information:
A copy of the specification
Name & address to whom the letter should be addressed
Your phone & fax number
What is the UL/FM requirement?
Insulation type and thickness?
Membrane and system?
Building location and height?